BRAINTRONICS Logo
CONTROL-1164.

General.

The CONTROL-1164 is used with an ISO-1064CE EEG Amplifier to form a stand-alone system with analog outputs for connection to an AD Converter (universal acquisition and analysis environment). The CONTROL-1164 converts the digital EEG signals of the EEG-1064CE amplifier into analog, adds a selectable 4th order anti-aliasing filter and fully controls the functionality and modes of the EEG-1064CE Amplifier. The impedance check of the electrodes is displayed on a panel with an LED per electrode. The CONTROL-1164 is connected by a thin and flexible microphone-type cable to the ISO-1064CE amplifier.

The photo at the right is of the CONTROL-1132. Only the LED-field is different for the CONTROL-1164

   Control box 1164
Braintronics order number
:
 CONTROL-1164

 

Controller specifications.

Control-1164
Input selection: CAL - mV - kohm - EEG
•

mV Full scale switch: 8 mV, 4 mV, 2 mV, 1 mV, 0.5 mV, and 0.25 mV
•
4th order anti-aliasing low pass filter: 15 Hz, 35 Hz, 70 Hz and 100 Hz
•
High Pass fiter, time constant: 1 sec, 0.3 sec and 0.1 sec
•
NOTCH filter 50Hz
•
Selectable calibration voltage:
10 µV, 20 µV, 50 µV, 100 µV, 200 µV, 500 µV, 1000 µV and 2000 µV
•
Selectable Common Mode Test Voltage:
0.05 mV, 0.1 mV, 0.2 mV, 0.5 mV, 1 mV, 2 mV, 5 mV and 10 mV
•
Electrode test indication panel
•

Electrode test level (mV):
2 mV, 5 mV, 10 mV, 20 mV, 50 mV and 100 mV
•

Electrode test level (kohm):
5 kohm, 10 kohm, 20 kohm, 50 kohm, 100 kohm and 200 kohm
•
AUT/MAN switch for calibration signal
•
POLYGRAPHY switch: selects between EEG and Polygraphy for upper channels
•

NO BOX indicator: detection of a disconnected ISO-1064CE amplifier
•

 

Braintronics address